Lipofectamine LTX Reagent is a proprietary, animal-origin free formulation for the transfection of DNA into eukaryotic cells with low cytotoxicity. This reference provides a recommended procedure to transfect plasmid DNA into COS-7 Monkey Kidney Fibroblasts (ATCC Cat. No. CRL-1651) using Lipofectamine LTX Reagent (Cat. No. 15338-100).
Important Guidelines for Transfection
Follow these important guidelines when transfecting DNA into COS-7 cells using Lipofectamine LTX Reagent:
- The addition of antibiotics to media during transfection may result in cell death, and has not been tested for COS-7 cells. If you wish to use antibiotics during transfection, test your conditions thoroughly.
- Maintain the same seeding conditions between experiments. Use low-passage cells; make sure that cells are healthy and greater than 90% viable before transfection.
- Transfection can be performed both in the presence or absence of serum. Test serum-free media for compatibility with Lipofectamine LTX Reagent.
- Using PLUS™ Reagent (Cat. No. 11514-015) enhances transfection performance in COS-7 cells.
- We recommend Opti-MEM I Reduced Serum Medium (Cat. No. 31985-062) to dilute the DNA and Lipofectamine LTX Reagent before complexing.
- Visit www.lifetechnologies.com/transfection or contact Technical Service for other specialized transfection protocols (including cell-type specific advice on use of PLUS™ Reagent and antibiotics, and a protocol for vector-based RNAi).
- Lipofectamine LTX Reagent performs well with vector-based RNAi experiments. For siRNA and Stealth™ RNAi transfections, we recommend Lipofectamine™ RNAiMAX (Cat. No. 13778-075). Go to www.lifetechnologies.com/RNAi or contact Technical Service for more information.
Have the following reagents on hand before beginning:
- COS-7 cells maintained in DMEM supplemented with L-glutamine (Cat. No. 11965-084), 0.1 mM MEM Non- Essential Amino Acids Solution (Cat. No. 11140-050), and 10% Fetal Bovine Serum (Cat. No. 26140-079). Grow cells at 37°C with 5% CO2.
- Plasmid DNA of interest (100 ng/μl or higher)
- Lipofectamine LTX Reagent (store at +4°C until use), and PLUS™ Reagent (if desired; store at 4°C)
- Opti-MEM I Reduced Serum Medium
- Appropriate tissue culture plates and supplies
- The day before transfection, trypsinize and count the cells. Plate 5 x 104 cells per well in 0.5 ml of complete growth medium. Cell density should be 50~80% confluent on the day of transfection.
- For each well of cells to be transfected, dilute 0.5 μg of DNA into 100 μl of Opti-MEM I Reduced Serum Medium without serum.
- If using PLUS™ Reagent: Mix PLUS™ Reagent gently before use, then add 0.5 μl PLUS™ Reagent (a 1:1 ratio to DNA) directly to the diluted DNA. Mix gently and incubate for 5-15 minutes at room temperature.
- For each well of cells, dilute 1.25-2.25 μl of Lipofectamine LTX into the above diluted DNA solution, mix gently and incubate for 25 minutes at room temperature to form DNA-Lipofectamine™ LTX complexes.
- Remove growth medium from cells and replace with 0.5 ml of complete growth medium. Add 100 μl of the DNA-Lipofectamine LTX complexes directly to each well containing cells and mix gently by rocking the plate back and forth.
- Complexes do not have to be removed following transfection. Incubate the cells at 37°C in a CO2 incubator for 18-24 hours post-transfection before assaying for transgene expression.
To transfect COS-7 cells in different tissue culture formats, vary the amounts of Lipofectamine LTX Reagent, DNA, cells, medium and PLUS™ Reagent used in proportion to the relative surface area, as shown in the table (amounts given on a per well basis).
|Culture vessel|| Surface
|Volume plating medium||Cells per well|| Volume
|96-well||0.3 cm2||100 μl||1.0 x 104||20 μl||100 ng||0.25 - 0.45 μl||0.1 μl|
|48-well||1 cm2||200 μl||2.5 x 104||40 μl||200 ng||0.5 - 0.9 μl||0.2 μl|
|24-well||2 cm2||500 μl||5 x 104||100 μl||500 ng||1.25 - 2.25 μl||0.5 μl|
|12-well||4 cm2||1 ml||1.0 x 105||200 μl||1 μg||2.5 - 4.5 μl||1.0 μl|
|6-well||10 cm2||2 ml||2.5 x 105||500 μl||2.5 μg||6.25 - 11.25 μl||2.5 μl|
1 Surface areas may vary depending on the manufacturer.
2 If the volume of Lipofectamine LTX Reagent is too small to dispense accurately, and you cannot pool dilutions, predilute Lipofectamine LTX Reagent 10-fold in Opti-MEM I Reduced Serum Medium, and dispense a 10-fold higher amount (should be at least 1.0 μl per well). Discard any unused diluted Lipofectamine LTX Reagent.