Applied Biosystems™

Septa Cathode Buffer Container, for 3500 and SeqStudio™ Flex

These septa are for both compartments of the Cathode Buffer Container, for use with the 3500 series Genetic Analyzers.

產品號碼	Quantity
4410715	10 Containers

產品號碼 4410715

價格 (TWD)

Quantity:

10 Containers

價格 (TWD)

These septa are for both compartments of the Cathode Buffer Container and are for use with 3500 and SeqStudio Flex series genetic analyzers.

For Research Use Only. Not for use in diagnostic procedures.

For Use With (Equipment)3500 Series Genetic Analyzers, SeqStudio Flex Series Genetic Analyzers

Product TypeSepta Cathode Buffer Container

Quantity10 Containers

Shipping ConditionRoom Temperature

Unit SizeEach

內容物與存放

This product contains 10 septa.

常見問答集 (常見問題)

When I started my run on the Applied Biosystems 3500/3500xL Genetic Analyzer, an error occurred: "Unstable Electrophoresis current detected, check for air bubbles" but I don't see any bubbles. What else can cause this?

Some of the other causes of an Unstable Electrophoresis current detected error message are:

1.Leak on the system
2. Polymer that:
-Has expired
-Has been left on the instrument for more than the recommended time
-Is a mixture of expired polymer and non-expired polymer
3. Running Buffer that was:
-On the instrument longer than 2 weeks
-Not filled to the fill line or evaporated below the fill line
4. An arcing event that was not cleaned afterwards using the water wash wizard
5. Not performing regular maintenance on the instrument
6. Hardware issues

Inspect the system for leaks. If you do not see any leaks on the system, perform the wash the pump chamber and channels wizard using the conditioning pouch and place fresh, non-expired polymer and fresh Anode and Cathode buffer containers. If the problem persists, a service call may be required.

Find additional tips, troubleshooting help, and resources within our Capillary Electrophoresis Instruments Support Center.

Do I need to replace the buffer every 14 days if the Applied Biosystems 3500/3500xL Genetic Analyzer is not in use?

If the instrument is not in use, it is not necessary to replace the buffer every 14 days. However, the buffer level needs to remain at the fill line to prevent the capillary or array from drying out. Top off the buffer volume with water if necessary. Replace the anode and cathode buffer containers prior to starting a new run.

Find additional tips, troubleshooting help, and resources within our Capillary Electrophoresis Instruments Support Center.